A half-dome cable is used to attach a cable to a frame.
The cable must be very thin to hold the frame together.
The manufacturer recommends a diameter of 1.8mm, but a good cable can be much thicker than this.
To do this, the cable must attach to a hole in the frame.
Here is how to do it: First, you need to unscrew a small piece of cable from the top of the frame so that you can easily pull the cable out.
Then, use a hammer to pry the cable from one side of the hole.
The resulting hole should be as small as the diameter of the cable you just unscrewed.
You can then remove the cable.
The next step is to take out the remaining cable.
There should be a small opening at the end of the middle part of the hook, which you can use to pierce a hole through the frame and open the cable up.
The last step is a little trickier, because you need the cable to be very tight to avoid damage to the frame from being pushed through the hole that was just made.
The best way to do this is to put the cable inside a hole made into the bottom of the bottom bracket.
Then take a small screwdriver and carefully push the cable into the hole, just to make sure the cable doesn’t go into the frame through the gap.